使用电动门事项
Precautions for using electric doors
1、接通电源，启动门排，检查电动门的保护功能是否正常。
1. Connect the power supply, start the gate bank, and check whether the protection function of the electric door is normal.
2、离合功能，可在停电时将电机的运行状态转换为手动状态。
2. The clutch function can switch the operating state of the motor to manual mode in the event of a power outage.
3、当您需要开启电动门时，可按控制箱或遥控器上的“开门”键，门体将自动向开门方向匀速运行，直至到位。
3. When you need to open the electric door, you can press the "Open" button on the control box or remote control, and the door body will automatically run at a constant speed towards the opening direction until it is in place.
4、当开关门时机头或门体卡住杂物时，应立即按“停止”键或切断电源，然后*杂物，以免造成不必要的损失。
4. When the machine head or door body gets stuck with debris when opening or closing the door, immediately press the "Stop" button or cut off the power, and then remove the debris to avoid unnecessary losses.
5、控制箱应放置在通风干燥处，以保证其性能稳定，延长电动门使用寿命。
5. The control box should be placed in a ventilated and dry place to ensure stable performance and extend the service life of the electric door.
6、需要关门时，按控制箱或遥控器上的“关”键，门体匀速向关门方向运行，直至到位。当要停止门体运行时，按“停止”键停止运行。
6. When it is necessary to close the door, press the "Close" button on the control box or remote control, and the door body will run uniformly towards the direction of closing the door until it is in place. When you want to stop the operation of the door body, press the "Stop" button to stop the operation.
7、当您购买具有遥控功能的电动门产品时，可以在遥控器上完成控制盒上的功能。遥控距离在20-30m之间（视现场而定）。如果遥控器距离比正常使用更近（或指示灯变暗），请更换线材。
7. When you purchase an electric door product with remote control function, you can complete the functions on the control box on the remote control. The remote control distance is between 20-30m (depending on the site). If the remote control is closer to normal use (or the indicator light becomes dim), please replace the wire.
注意事项
matters needing attention
1、定期检查道路上是否有垃圾，及时跟踪清理。运行过程中如有障碍物，应及时切断电源。打开电动门时，动作要轻。用力过猛会损坏电动门。
1. Regularly check if there is any garbage on the road and promptly track and clean it up. If there are obstacles during operation, the power should be cut off in a timely manner. When opening the electric door, the action should be gentle. Excessive force can damage the power door.
2、电动门在使用过程中要经常清洁，时刻保持表面清洁。如果发现污渍和污垢，可以用水、酒精或中性清洁剂清洗。一般建议使用柔软的纱布或棉纱擦拭，以免划伤电动门，造成表面划伤。
2. Electric doors should be regularly cleaned during use and their surface should be kept clean at all times. If stains and dirt are found, they can be cleaned with water, alcohol or neutral detergent. It is generally recommended to use soft gauze or cotton yarn to wipe to avoid scratching the electric door and causing surface scratches.
3、由于电动门主要由铝合金型材和不锈钢材定送水  铜鼎铜钟 淤泥固化设备 化粪池钢模具 拱形骨架模具 保定代理记账 保定道闸
料制成，虽然具有一定的耐腐蚀性，但应采取相应的预防措施。使用过程中，尽量避免接触酸性和碱性化学品，以免损坏表面。
3. Due to the fact that electric doors are mainly made of aluminum alloy profiles and stainless steel materials, although they have certain corrosion resistance, corresponding preventive measures should be taken. During use, try to avoid contact with acidic and alkaline chemicals to avoid damaging the surface.
4、电动门的五金配件要定期检查，长期使用会损坏五金配件。一般来说，在这种情况下，需要及时修理或更换。同时
4. The hardware accessories of electric doors should be regularly inspected, as long-term use can damage the hardware accessories. Generally speaking, in this situation, timely repair or replacement is necessary. meanwhile